Observed arrival · 2026-10-31
BeamCarve: galvo-laser software with photo-to-relief carving
BeamCarve offers free 2D engraving software for BJJCZ/EZCAD2 fiber lasers, with a paid add-on for carving 3D reliefs from photos.
○Open
⊠Login
$Paid
†Ads
✦Pretty
●Pro
◎Niche
◉Human
⚑Risk
ƒJS
- For
- BJJCZ fiber-laser owners using EZCAD2
- Worth noticing
- It imports EZCAD2 setup parameters, then uses a 40 mm frame and two red-light checks to correct scale and direction.
Field notes
The page explains a setup workflow rather than stopping at a compatibility list: users can import laser settings from an EZCAD2 folder, or enter them manually, then check the field with a 40 mm frame. It also describes a Windows driver switch because EZCAD2 and BeamCarve cannot use the controller board at the same time; macOS is listed as needing no driver.
Observed signals
Read the marks
Editorial observations of this landing page, not a rating.
○OpenPublic substance visible
$PaidCommerce or pricing visible
✦PrettyNotable craft visible
●ProPolished or operationally mature
◎NicheUnusually specific use
One card from the complete issue