Skip to the card

2026-11-18 issue

Observed arrival · 2026-11-18

Auto Therm’s steel-furnace control system

auto-therm.com Visit website
Editorial interest 77/100 Selection signal · not a rating of the site

Auto Therm presents a layered combustion and temperature-control system for steel billet reheating furnaces, with gas use, scale, and emissions as its targets.

Landing page captured for the 2026-11-18 issue.
For
Steel mills operating billet reheating furnaces
Worth noticing
The sample HMI is labeled illustrative; savings remain model estimates until checked against metered gas and measured scale.

Field notes

The control layers are described separately: burner ratio, oxygen trim, zone temperatures, and a later billet thermal model. The page says a mill can begin with combustion control and add other layers. It also distinguishes process control on a Siemens PLC from the separate burner-management and flame-safety system, and says study values carry source information.

Observed signals

Read the marks

Editorial observations of this landing page, not a rating.

○OpenPublic substance visible
⊠LoginAccess appeared gated
✦PrettyNotable craft visible
◎NicheUnusually specific use

One card from the complete issue

Before Paste Became a Command

370,543 arrived 1,000 judged 990 catalogued Enter the complete issue
auto-therm.com

Landing page observed 2026-11-18. The live site may have changed.