Skip to the card

2026-11-18 issue

Observed arrival · 2026-11-18

WeldBook keeps the settings attached to the weld

weldbookapp.com Visit website
Editorial interest 78/100 Selection signal · not a rating of the site

A machine-specific welding guide and log that combines manufacturer references with saved settings for individual weld setups.

Landing page captured for the 2026-11-18 issue.
For
Welders tracking machine-specific setups and test welds
Worth noticing
The Miller reference is marked verified only for 240V, C25, ER70S-6, DCEP, and .030″ or .035″ wire.

Field notes

Shop defaults include wire diameter, shielding gas, machine supply, and wire type, while each weld has its own material, joint, position, and technique inputs. The page identifies its Miller source as manual OM-265809F, section 6-4, and notes that the cited factory values are dial references rather than actual volts or inches per minute. For the Everlast PowerSet, it directs users to read values from the welder and record them, rather than supplying a numeric chart.

Observed signals

Read the marks

Editorial observations of this landing page, not a rating.

○OpenPublic substance visible
⊠LoginAccess appeared gated
✦PrettyNotable craft visible
●ProPolished or operationally mature
◎NicheUnusually specific use

One card from the complete issue

Before Paste Became a Command

370,543 arrived 1,000 judged 990 catalogued Enter the complete issue
weldbookapp.com

Landing page observed 2026-11-18. The live site may have changed.